1. Low pressure vacuum carburizing The conventional gas carburizing in Guangdong machining plant is easy to produce surface oxidation (Igo), and non martensitic structure appears in the thin layer of the surface of the carburizing layer, which reduces the fatigue performance of gears. Low pressur...

The following are the routine maintenance items of horizontal machining center (as shown in Figure 1) in Dongguan CNC processing plant, including maintenance frequency, coolant capacity and type. In order to make the machine work normally and protect the warranty right, the user must comply with ...

The general WEDM in Guangdong machining factory is a typical two axis CNC machine tool, which can only be used for cutting various two-dimensional graphics, and its processing range is narrow. How to broaden the processing range of ordinary WEDM machine tools, so that it can better meet the objec...

In 1931, Salomon's high-speed machining theory of Dongguan CNC processing plant obtained a German patent. He believed that "when the cutting speed is 5-10 times higher than the conventional cutting speed, the cutting temperature of the blade will begin to decline...". It can be concluded from the...

As entrepreneurs, we are all on our own way. For some, financial success is a long and painful process. For others, things just seem to happen when it's time. I believe that the latter is not the result of magic, but a clear sign that an entrepreneur realizes the importance of learning, adapting ...

3、 Problems of short circuit and distortion of cutting path in aluminum cutting one Cause analysis of the problem In the daily processing of Guangdong mechanical processing plant, it is difficult to cut large thickness workpiece, because the workpiece is thick to a certain extent, there is not en...

2、 The problem of workpiece deformation 1. Causes of workpiece deformation Due to the effect of uneven heating, phase transformation of internal structure and deformation of workpiece during blank manufacturing, cutting and heat treatment in Guangdong machining plant, the residual stress is gener...

Dongguan CNC factory shares with you: flexible manufacturing cell The flexible manufacturing cell (FMC) of Dongguan CNC plant is considered as a flexible manufacturing subsystem. The following are the differences between FMC and FMS: 1. FMC is not directly controlled by the central computer, and ...

Dongguan CNC processing plant 1. The speed of white steel knife should not be too fast. 2. Copper workers use less white steel knives and more flying knives or alloy knives. 3. When the workpiece is too high, it should be roughened by layers with knives of different lengths. 4. After roughening w...